Delta 10" Table Saw Restoration | Electrical Controls | P8 [Yxyu5GwgcAk]

Delta 10" Table Saw Restoration | Electrical Controls | P8 [Yxyu5GwgcAk]

| 1h 28m 28s | Video has closed captioning.

I install the magnetic motor starter electrical controls, Jointer Chip Chute, Belts and Adjust the Motor Brushes. Delta Table Saw & Jointer Restoration. This is a Model 1160 Delta 10" Tilting Table Cabinet Style Table Saw, built somewhere between 1937 and 1941. The table saw is a tilting table cabinet saw. The table saw has been in the family since new. The Jointer is a Model 654, 6" Jointer (Old Style). This Jointer was supplied on the same stand as the Table saw, using the same motor. Gary Brown of Old Iron Machine Works on You Tube donated the correct Jointer for this project. Be Sure to check out: Part 1: Part 2: Part 3: Part 4: Part 5: Part 6: Part 7 - 1: Part 7 -2: Part 8: Part 9: Badges Installation: Old Iron Machine Works : 00:00 - Intro 00:42 - Jointer Chip Chute 01:36 - Motor Positioning 04:26 - Belt Setup & Install 07:52 - Test Run & Speed Check 09:54 - Final Wiring & Starter Install 13:13 - Motor Run no Load 13:48 - Motor Run with load and Tool Speed Check 15:44 - Outro Some of following links are Amazon Associate links. As an Amazon Associate I earn from qualifying purchases. Link Belts: Extension Cord: Magnetic Starter: Pully's : Please Support the channel: 🎯Buy Me Coffee: 🎯Subscribe: 🎯Instagram: 🎯Knocker, Dovetail Cutter and Scribe info: Email To: [email protected] #deltatablesaw#restoration#tablesaw